If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

I asked how to make SCI break last time and TI expert told me that I can make SCI break with GPIO control. In data sheet : SCI is low for 9.625 bit following a missing stop bit. (Start 1bit + data ...

It seems both Windows (192kHz max?) and Linux (ALSA: 384kHz) have maximum hardware audio capture sampling rates below 768kHz. When a sound recording application like Audacity is asked to capture at ...

I can't download my firmware(.out) to CC2745R10 EVB with LP-XDS110 download debugger.(I chose Part number:CC2745P10 because there is no CC2745R10.) Here is a my trouble shooting. 1. Hardware Setup Set ...

sdhci_send_command: MMC: 1 busy timeout increasing to: 200 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 400 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 800 ms.

I would like to copy over a default image of Linux from an SD card into the eMMC. I currently have copied U-Boot over by following this tutorial: ...

1、M3与TCAN4550的SPI通信正常：表现为读DEVICE ID正常；初始化寄存器的时候进行写后，回读与写的值比较，均通过； 2、M3与TCAN4550的SPI通信连接；TCAN4550与上位机通过CAN2.0B调试工具，，通过如下 ...

I have a program that demands additional data memory to run on the ARM core of the AWR1843BOOST. To allocate more memory for data, I adjusted the mmwave_sdk_xwr18xx.mak file in the mmWave SDK 3.6.0 as ...

I am designing a BMS around BQ76922 and I went through its datasheet and it doesn't specify that it have in-built ESD protection for cell measurement connections. I also went through BQ76922EVM user ...

I have a problem with running my CLA CODE when I run my program in flash. When i run thise program in RAM, i don't have these problems. Problem description: CLA TASK1 is triggered by int 6.11 (SD1).

I understand from the Sys/Bios download page that ver. 6.83 supports CCSv10.1.0 or higher. Our customer would like to know how to create a Sys/Bios project in CCS ver. 12. Are the training videos in ...

The short answer is yes it is usable but for low frequencies. The RES60-Q1 is optimized for DC and low frequency applications. We don't have data for AC measurements and some of the specs are TBD. For ...